| 年份 | | | | | | |
| | | | | | Residual Stress Nondestructive Testing for Pipe Component Based on Ultrasonic Method |
| | | | Elastic waves characteristics in thick-walled hollow cylinders with internal/external surface excitation for train axle monitoring |
| | | Emissivity-adjusted based depth profiling in eddy current pulsed thermography |
| | | | Phased Array B-scan Acoustic Field Simulation of Aluminum Extrudate FSW Welds with Complex Shapes |
| | | Modified Synthetic Focusing with Direction of Arrival Function for Ultrasound |
| | | Ultrafast Surface-Inspecting Laser Scanner |
| | | | | |
| | | | 時頻分析方法測量GLARE板中空氣耦合蘭姆波的頻散特性 |
| | | |
| | | | 基于柔性渦流探頭的托卡馬克內部線圈導體偏心渦流檢測方法研究 |
| | | 激光超聲檢測的有限差分模擬及實驗驗證 |
| | | SIFT算法應用于車底圖像特征信號提取的對比分析 |
| | | | | | Acoustoelastic Lamb wave analysis in thin plates |
| | | | Cross-correlation Phase Correction Method on Ultrasonic Synthetic Focused Signal Distortion |
| 南京航空航天大學/紐卡斯?fàn)柎髮W(xué) | | Ferrite-yoke based pulsed induction thermography for cracks quantitative evaluation |
| | | | Quantitative determination of surface cracks by the laser optoacoustic method |
| | | Analysis of Dynamic Characteristic for Ultra-thin Coating Layer with Ultrasonic Atomic Force Microscopy |
| | | Study on Focusing Characteristics of Curved Phased Array Probe |
| | | Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders |
| | | | | 基于巴克豪森原理的Q235鋼不同深度應力分布檢測研究 |
| | | | 基于系統辨識的脈沖渦流信號提離效應分析 |
| | | |
| | | | |
| | | 薄壁管環焊縫超聲水浸 TOFD檢測技術研究 |
| | | 鐵磁性材料脈沖渦流檢測信號消噪方法的研究 |
| | | 多層管熱等壓焊接界面電磁超聲檢測方法及數值模擬 |
| | | | | | Research of SNR Enhancement for Coarse-grained CASS Based on Phase Coherence Imaging |
| | | | Experimental Study of Turbine Disk Residual Stress Measurement Using Lcr Wave |
| | | Feasibility study of Debonding NDT for Multi-layer met-al-metal bonding structure by using eddy current pulse thermography |
| | | | Unidirectional Line-Focusing Shear Vertical Wave EMATs used for rail base center flaw detection |
| | | Experimental investigation into Probability of Detection for Fatigue Cracks in Sonic IR Imaging |
| | | Multi-aperture focus ultrasonic imaging technique based on virtual source |
| | | Localization and Evaluation of Subsurface Pits in Copper Pipes Using Gradient-field Pulsed Eddy Current Inspection |
| | | | | 基于脈沖渦流/電磁超聲復合檢測方法的復雜缺陷檢測 |
| | | | 基于變徑檢測的管道凹陷應變計算方法研究 |
| | | |
| | | | 基于ACSM法鐵磁構件殘余應力測量研究 |
| | | 脈沖擾動電磁場非表面缺陷埋深識別算法研究 |
| | | 結構不連續處應力與磁記憶檢測信號量化關系研究 |
| | | 表面裂紋激光紅外檢測的數值模擬及定量重構 |
| | | | | | Statistical properties of Barkhausen Noise with 180 degree domain wall for stress characterization and grain boundary effects |
| | | | Development of Electromagnetic nondestructive testing for inspecting mechanical lap joint of high-temperature superconducting tapes |
| | | Recognition of key targets of locomotive bottom based on 3D point cloud data |
| Nanyang Technological University | | An adaptive regularization method for limited view thickness reconstruction |
| | | | patial-time-step Features Fusion algorithm in Eddy Current Pulsed Thermography |
| | | Probability of Detection for Fatigue Crack in Pulsed Eddy Current Thermography |
| | | Effects of interlaminar electrical behavior on eddy currents in carbon fiber composite materials |
| | | Circumferential current field testing method for inspection of inner-wall cracks in aluminum tube |
| | | Welding Defects Detection and Classification by Using Eddy Current Thermography |
| University of Texas at Dallas | | Power Efficient Ultrasound Imaging Diagnosis System Using Adaptive Data Prediction Scheme |
| | | | | 碳鋼塑性變形對增量磁導率信號的影響分析 |
| | | | |
| | | 球墨鑄鐵QT400-18石墨球化率對超聲聲速的影響 |
| | | 雙線圈渦流位移檢測探頭結構參數優化 |
| | | | 相控陣超聲檢測耦合狀態自動評判法則的研究 |
| | | |
| | | 基于PEC技術的雙層導電涂層厚度檢測方法研究 |
| | | 奧氏體鍋爐管氧化皮堆積厚度脈沖渦流檢測實驗研究 |
| | | |
| | | 大范圍檢測和監測的全指向SH導波壓電換能器 |